JVC RA-D51 - System and Display Adjustments; Factory System Reset

16
System Reset
There may be times when you need to reset your unit back to the factory settings,
especially if you have moved house or if you experience reception problems.
If you move to another part of the country and pick up the local and national DAB stations
in that area, your previously tuned channels may no longer be available.
1. Press and hold the MENU/INFO button, then turn
the VOLUME SELECT dial until “System” shows on
the display.
2. Press the VOLUME SELECT dial, then turn the
VOLUME SELECT dial until “Factory Reset” shows
on the display.
3. Press the VOLUME SELECT dial, then turn the
VOLUME SELECT dial until “Factory Reset?”
shows on the display. Turn the VOLUME SELECT
dial to choose Yes, then press the VOLUME
SELECT dial to conrm. After the reset is
complete, the unit will go to standby mode.
4. Press the
STANDBY button again to turn the unit on, the unit will then start scanning
for DAB channels immediately.
After the system reset, all the tuned stations, DAB and FM preset stations and alarm settings will be
erased.
Display Backlight
There are four backlight levels to choose from.
To set the backlight level, repeatedly press the DIMMER/SNOOZE button and the
brightness of the display will change in sequence: Low > Medium > High > O >
JVC Wooden DAB Radio RA-D51 Manual.indd 16 11/09/2017 13:15