JVC RV-DP200BK - Using the Remote Control; Connecting Auxiliary Equipment; Connecting the Ac Power Cord

3
The Remote Control makes it easy to use many of the functions of the System from a distance of up to 7m (23 feet) away.
You need to point the Remote Control at the remote sensor on the System's front panel.
Note: If you point the Remote Control from the slant direction, the above distance will be shortened.
CAUTION: Make all connections before plugging the System into an AC power outlet.
Connect a signal cord (not supplied) between the AUX IN terminal on the System and the output terminals of your auxiliary equipment (e.g.
turntable or MD player). You can listen to this source.
Firmly insert the supplied AC power cord into the AC inlet on the back of the System.
The provided AC power cord for this System has certain one-way direction connections to prevent electric shock. Refer to the illustration for
correct connetion.
CAUTIONS:
• ONLY USE THE JVC POWER CORD PROVIDED WITH THIS SYSTEM TO AVOID MALFUNCTION OR DAM-
AGE TO THE SYSTEM.
• BE SURE TO UNPLUG THE POWER CORD FROM THE OUTLET WHEN GOING OUT OR WHEN THE SYS-
TEM IS NOT IN USE FOR AN EXTENDED PERIOD OF TIME.
Now you can plug the AC power cord into the wall outlet, and your System is at your command!!
Using the Remote Control
Connecting Auxiliary Equipment
Connecting the AC Power Cord
C D TAPE
POWER
AUX TUNER
PRESET
BAND
MULTI CONTROL
REW STOP FF
TUNING
ONE TOUCH
REC
STANDBY
MID /
TREBLE
SUPER WOOFER
VOLUME
VOLUME
MID TREBLE /
OPEN
Remote sensor
12V
DC IN
AC IN
AUX IN
PHONES
Pin-plug x 2
Stereo mini plug
Signal cord
(not supplied)
Turntable (with built-in equalizer) or
MD player (not supplied)
AC IN
Power cord
RD-DP200(J)-Eng.fm Page 3 Monday, December 25, 2000 2:45 PM