JVC RX-508VBK User Manual

RX-SO8VBK
RX-508VBK ;
RX-509VTN
i
RX-SO9VTN
Installation
This section explains how to connect the receiver to other stereo equipment and speakers, and Connecting Stereo Components
how to connect the power supply.
Before Starting You can connect the following components to the receiver:
ES Gouons i Audio components
+ Tumtable
Before installation 4X CAUTION! Before installing your receiver: ! + CD player
© Make sure yout tons are dry. + Two tape decks
© Turn the power off to all components. :
© Read the installation instructions for all components you are going to connect. Video wae
Positioning the Receiver A\ CAUTION! : _— disc player
© Install the receiver in a location thot is level and protected from moisture.
. tere around the receiver must be between 23° and 104° F (-5°
and 40° C). IMPORTANT! . j
. Nee sure there is good ventilation around the receiver. Poor ventilation lof r ee, log derpresp st Shoe ubipgtoatvor acd i
could cause overheating and dat the receiver. Amina |
ing image if they are reversed, the stereophonic image will not be correct.
i UTION!
pena fone a " | NOTE: To ensure correct connections, insert the red plug into the right channel.
nnesnons: * Do not handle the power cord with wet hands. '
* Do not pull on the power cord to unplug the receiver. Always grab the plug :
directly so as not to damage the cord. ! Basic Connections Connect stereo components to the amplifier using cables with RCA PIN plugs. If you are
.
7
i
for
Audio
Equipment
connecting
a
tape
deck,
connect
the
output
jacks
on
the
tape
deck
to
the
jacks
marked
IN
Handling the Receiver 4 CAUTION! (PLAY) on the receiver, and the input jacks to those marked OUT (REC).
© Do not insert any metal object into the receiver.
© Do not disassemble the receiver or remove screws, covers, or cabinet. NOTES: ;
© Do not expose the receiver to rain or moisture. i « Any aurniables incorporating a small-output cartridge such as an MC (moving-coil
type) must be connected to this amplifier through a commercial head amplifier or
step-up transformer. Direct connection may result in insufficient volume.
¢ Ifa ground cable is fitted to your turntable, connect the cable to the screw marked
GND on the rear panel.
CD PLAYER TAPE DECK 1
Page 4 Page 5
1-6 (No. 20376) (No. 20376) 1-7

JVC RX-508VBK Specifications

General

Brand	JVC
Model	RX-508VBK
Category	Stereo Receiver
Language	English