18
English
About characters shown on the display
When the display shows PS, PTY, or RT signals, the following characters are
used.
• The display cannot differentiate upper case and lower case letters and always
uses upper case letters.
• The display cannot show accented letters, “A”, for instance, may stand for
accented “A’s” like “Å, Ä, Ã, Á, À, and Â.”
What Information Can RDS Signals Provide?
You can see the RDS signals the station sends on the display.
To show the RDS signals
Press DISPLAY MODE while listening to an FM
station.
Each time you press the button, the display changes to
show you the following information:
PS (Program Service):
While searching, “PS” appears and then the station names will be displayed.
“NO PS” appears if no signal is sent.
PTY (Program Type):
While searching, “PTY” appears and then the type of the broadcast program will
be displayed. “NO PTY” appears if no signal is sent.
RT (Radio Text):
While searching, “RT” appears and then text messages the station sends will be
displayed. “NO RT” appears if no signal is sent.
Station Frequency:
Station frequency (non-RDS service)
When pressing DISPLAY on the remote control:
Make sure that you have selected FM station using the
remote control.
If not, the DISPLAY button does not work for tuner
operation. (Pressing TUNER/BAND activates the
remote control for tuner operation.)
PS PTY RT Frequency
Notes:
• If searching finishes at once,
“PS”, “PTY”, and “RT” will not
appear on the display.
• Even if you press DISPLAY
MODE (or DISPLAY) while
listening to an AM (MW/LW)
station, the display only shows
station frequency.
• RDS is not available for AM
(MW/LW) broadcasts.
DISPLAY MODE
DISPLAY
A, Å, Ä,
Ã, Á, À, Â
B
C, C, C
D, D
E, Ë, É,
È, Ê
F
G
H
I, Ï, Í, Ì, Î
J
K
L
M
N, Ñ
O, Ö, Õ, Ô,
Ò, Ó, Ø
P
U, Ü, Ú,
Ù, Û
V
W
X
Y
Z, Z, Z
Q
R, R, R
S, S, S
T
0
1
2
3
4
5
6
7
8
9
*
+
-
,
.
/
–
–
–
<
>
=
\
'
RX-554RBK(EE)_0118-001A_En01-23 98.1.30, 2:20 PM18
To Next Page
Loading...
Need help?
General
