To Next PageTo Next Page
Need help?Do you have a question about the JVC RX-554RBK and is the answer not in the manual?
General| Channels | 5.1 |
|---|---|
| Audio Formats | Dolby Digital, DTS |
| FM Tuner | Yes |
| Bluetooth | No |
| Total harmonic distortion | 0.08% |
| Input sensitivity | 200 mV |
| Input Sensitivity/Impedance | 200 mV / 47 kOhms |
| Tuning range | FM: 87.5 - 108 MHz |
| Frequency response | 20 Hz - 20 kHz |
| Video Connections | Composite video, HDMI |
| Speaker load impedance | 6 ohms |
| Speaker Impedance | 6 ohms |
Critical safety instructions for UK users, including mains plug and fuse handling.
Statement of compliance with Italian ministerial decree for product safety and regulations.
Identification and function of buttons and indicators on the receiver's front panel.
Diagram and explanation of buttons and functions on the JVC remote control.
Guidance on proper placement, handling, and initial preparation before connecting components.
List of included accessories to verify upon unpacking the receiver.
Instructions for connecting the supplied FM antenna or a standard type connector.
Steps to connect the AM loop antenna for optimal reception.
How to connect two sets of front speakers to the receiver's front speaker terminals.
Procedure for connecting rear and center speakers to the respective receiver terminals.
Guide to connecting audio sources like turntables, CD players, and cassette decks.
Instructions for connecting video sources like VCRs and video disc players.
Information on connecting JVC audio components for remote control system operation.
Instructions on how to properly connect the receiver's power cord to an AC outlet.
Guide on inserting batteries into the remote control for proper operation.
How to turn the receiver on, off, or place it in standby mode using front panel or remote.
Instructions for choosing and switching between different audio input sources.
How to adjust the audio volume using the receiver's front panel or remote control.
Guide to selecting which set of connected front speakers to use.
How to temporarily silence the audio output through the MUTING button.
Instructions for recording audio from a selected source to a connected deck.
How to listen to audio privately using headphones, including necessary speaker settings.
How to equalize sound levels between the left and right front speakers.
Enabling the Loudness function to boost bass at low volume levels.
Setting the receiver to automatically turn off after a specified period.
Explanation of how the function stores and recalls sound settings for different sources.
Steps to store new sound settings and recall previously memorized settings.
How to manually tune into FM and AM radio stations using the receiver's controls.
Storing and recalling favorite radio stations using the preset tuning function.
Choosing between FM AUTO and FM MONO modes for optimal reception.
Receiving and displaying station name, program type, and text messages via RDS.
Simulating surround sound with two front speakers using JVC's 3D-PHONIC technology.
Digital Acoustic Processor mode for creating realistic concert hall or club sound environments.
Introduction to Dolby Surround and JVC Theater Surround modes for enhanced audio.
Choosing and applying preset sound effect modes like Movie, Sports, or Music.
How to disable the currently active preset SEA mode by selecting 'OFF'.
Optimal speaker placement when using center and rear speakers for surround sound.
Optimal speaker placement when using only rear speakers for surround sound.
Optimal speaker placement when using only a center speaker for surround sound.
Steps to select and adjust surround modes like PROLOGIC, 3CHLOGIC, or THEATER.
Guide to selecting and adjusting DAP modes (Dance Club, Live Club, Hall, Pavilion) on the front panel.
Instructions for selecting and adjusting DAP modes using the remote control.
Selecting surround modes (PROLOGIC, 3CHLOGIC, THEATER) from the front panel.
Selecting surround modes using the remote control for convenient operation.
Operating JVC components using the receiver's remote sensor.
How components automatically turn on/off and switch sources via COMPU LINK.
Setting up synchronized recording between a CD player/turntable and a cassette deck.
Detailed technical data for the receiver's amplifier section, including output power and distortion.
Specifications for FM reception sensitivity, selectivity, and frequency response.
Specifications for AM reception sensitivity, selectivity, and tuning range.
Overall specifications including power requirements, consumption, dimensions, and mass.
Instructions for controlling CD players and CD changers using the receiver's remote.
How to operate a connected cassette deck, including playback and fast wind functions.
Instructions for controlling VCR functions like playback, rewind, and channel selection.
How to control TV functions such as input mode, volume, and channel selection.
