To Next PageTo Next Page
Need help?Do you have a question about the JVC RX-6510VBK and is the answer not in the manual?
General| Channels | 5.1 |
|---|---|
| Tuning range | AM/FM |
| Input sensitivity | 200mV (line) |
| Video Connections | Composite |
| Speaker load impedance | 8 ohms |
| Power Output | 100 watts per channel |
| Inputs | 4 audio |
Covers warnings about fire, electric shock, moisture, opening the unit, and proper handling.
Specific caution regarding the receiver's power switch and its relation to the mains line.
Guidelines for proper placement and spacing to ensure adequate ventilation and prevent overheating.
Identification of buttons and indicators on the remote control unit.
Identification of controls, terminals, and indicators on the receiver's front panel.
Covers pre-installation steps, location, handling, and checking supplied accessories.
Instructions for connecting FM and AM antennas for radio reception.
Details for connecting cassette decks, CD recorders, and VCRs using analog inputs/outputs.
Instructions for connecting digital sources like TVs, DVD players, and CD players.
How to turn the receiver on/off and select different audio/video sources.
Explanation of signal and speaker indicators on the receiver's display.
Procedures for recording sources and adjusting front speaker output balance.
How to rename sources and register subwoofer presence.
Registering components to specific DIGITAL IN terminals (e.g., coaxial, optical).
Switching between analog and digital input modes for source components.
Manual tuning and using the preset function to find radio stations.
Explains Digital Signal Processor modes and introduces types like Surround and DAP.
Details Dolby Surround, DTS Digital Surround, and JVC Theater Surround modes.
Adjusting speaker output levels for Dolby and DTS surround modes.
Adjusting speaker output levels and effect levels for DAP modes.
Steps to activate Surround and other DSP modes.
Steps to deactivate currently active DSP modes.
Information on connecting and using the COMPU LINK system for component control.
Instructions for performing synchronized recording between components.
Operating JVC tuners, amplifiers, and CD players using the receiver's remote.
Operating JVC VCRs and DVD players using the receiver's remote control.
Operating JVC televisions using the receiver's remote control.
Programming the remote control to operate other manufacturers' TVs.
Solutions for problems like no display, no sound, or sound from only one speaker.
Solutions for issues like continuous hiss, buzzing, or cracking noise during FM reception.
Addressing 'OVERLOAD' display and 'DSP MICON NG' error messages.
Solutions for when the remote control does not work or operate as intended.
Detailed specifications for the amplifier section, including output power and frequency response.
