JVC RX-807VTN

RX-807VTN
@ /PD7001C(IC434) : A/D Converter
1. Terminal Layout
ToC
DL
—
SCK
so
cs
CLO
clit
On au h Wn
2. Block Diagram
Vdd DL SI SCK sO EOC
© ©) © © ©
ssheus f sti otes pi ere et ee eremian | Are
1
1 VV
' ©) ©
!
t uae
ANALOG! es CM)
INPUT : O C) ©
A1C i] MULTI ADDRESS
A20O : PLEXER LATCH
A3 0 X)
1
!
1
' SEQUENTIAL
1
REGISTER
Vred ee CONTROLLER
1 |
haere 5
8BIT D/A
ANALOG
GND
1
Soe erae | iiieeti cance tapendidesee dt waemteatae cent aice
°
Vss
MITC74HC595AP(IC251,252) : 8 Bits Shift Register
1. Terminal Layout 2. Function Table
Function
jer | scx | scur| rc |
x
ae | x | x | H [ouputiqa-ch) disable,
ars Output (QA-QH) enable
ac | 6
Qu| 7 Shift register is cleared.
GND | 8
Condition of shift register in initial stage is “L”. In the
other stages, data from the former stage is stored.
Condition of shift register in initial stage is “H“. In the
other stages, data from the former stage is stored.
Shift register data is stored in the storage register.
Shift register does not change.
X: Don't care
(No. 20333) 1-31