Why is the picture from my JVC Home Theater System blurred or divided?
If the picture is blurred, divided, or not displaying at all, the scan mode might be set to “PROGRESSIVE” when your TV doesn't support progressive video input. Change the scan mode to “INTERLACE”.
How do I adjust the bass level for stereo sound on my JVC SP-PWA85 Home Theater System?
If the bass sound is too strong when listening in stereo, it means that the appropriate bass level for stereo sound is not selected. Adjust the “AUDIO POS” setting properly.
What to do if there is no sound from my JVC SP-PWA85?
If you're not getting any sound, first check that the system cord and speaker cords are properly connected. Also, check for any shorts in the speaker cord and reconnect if necessary. Ensure the audio cord is correctly connected to AUDIO IN (VCR) and/or DIGITAL IN (DBS). Make sure that you have selected the correct source and that muting is not enabled – press MUTING to cancel. Finally, verify that the decode mode is set correctly.
What does it mean when my JVC SP-PWA85 displays “0:00” and won't play a disc?
If the display window shows “0:00” and the disc won't play, the disc may be loaded upside down. Load the disc correctly. It is also possible that the disc is unplayable, so replace the disc.
Why is there no sound from the center or surround speakers on my JVC SP-PWA85?
If you're not getting any sound from the center and/or surround speakers, the speaker setting may be incorrect. Make sure to set the speaker setting properly.
Why is sound only coming from one front speaker on my JVC SP-PWA85?
If sound is only coming from one front speaker, first verify that the speaker cord is correctly connected. If the connection is good, check that the left-right balance is properly adjusted.
Why are the video and audio distorted on my JVC Home Theater System?
If the video and audio are distorted, the disc may be scratched or dirty. Try replacing or cleaning the disc. If a VCR is connected between the center unit and the TV, connect the center unit and TV directly. Also, with some discs, a picture may be blurred when setting “PICTURE SOURCE” to “FILM” or “AUTO”; try setting “PICTURE SOURCE” to “VIDEO (NORMAL)” or “VIDEO (ACTIVE)”.
How to reduce noise when listening to radio on my JVC SP-PWA85?
To improve broadcast quality, ensure the antennas are correctly and securely reconnected. If using the AM loop antenna, adjust its position and direction, as it might be too close to the center unit. For FM broadcasts, fully extend and optimally position the supplied FM antenna. If listening to AM, experiment with different Beat Cut modes.
How to restore power to the subwoofer on my JVC Home Theater System?
If the powered subwoofer isn't receiving power, first ensure that the power cord of the subwoofer is firmly plugged into an AC outlet. Turn off the system, plug the power cord into the outlet, and then turn the system back on. Also, check that the system cord is properly connected.
Why can't I play a disc on my JVC Home Theater System?
There are a few reasons why a disc might not play. First, check if the center unit’s and disc’s Region Code numbers are compatible; if not, replace the disc. Also, Parental Lock may be enabled; enter the password to change the Parental Lock level. If you are trying to play MP3 files, make sure that MP3 files have the file extension in their file names. If you are trying to play JPEG files, make sure that JPEG files have the correct file extension in their file names. If no MP3 or JPEG files are recorded to the disc, replace the disc.
General| Brand | JVC |
|---|---|
| Model | SP-PWA85 |
| Category | Home Theater System |
| Language | English |
To Next Page
