JVC TH-M603

Connections
13
NOTE
• The way of connecting the system cord varies depending on the type
of the powered subwoofer.
You can enjoy the sound of an analog component.
NOTE
• The signals input to the VIDEO jack of the VCR IN jacks will be
output only from the VIDEO jack of the VIDEO OUT jacks, not from
the S-VIDEO jack of the VIDEO OUT jacks.
You can enjoy the sound of a digital component.
* DBS = Direct Broadcasting Satellite
NOTE
• Only digital audio signals can be input when selecting “DBS” as the
source to play. (A pg. 18) When connecting a video component such
as a DBS tuner, operate this system to listen to the sound.
To avoid damaging the powered subwoofer, set the VOLTAGE
SELECTOR switch to the voltage of your area.
When you change the position of the VOLTAGE SELECTOR
switch, use a tool such as a slotted screwdriver, etc.
CAUTION
DO NOT plug the power cord of the powered subwoofer
before setting the VOLTAGE SELECTOR switch to the
correct voltage.
Connecting the powered
subwoofer
Connecting to an analog
component
Powered
subwoofer
System cord
(supplied)
Center unit
Align the 5 marks. Align the 5 marks.
RCA pin plug
cord
(not supplied)
A To composite video output
B To S-video output
C To audio output
AB C
Center unit
VCR (A C or B C)
TV (C)
Cassette recorder (C)
Composite video
cord
(not supplied)
S-video cord
(not supplied)
or
Connecting to a digital
component
Setting the VOLTAGE
SELECTOR switch
Digital optical cord (not supplied)
To digital optical output
DBS
* tuner
MD recorder
Center unit
TH-M603-303[UJ]-04Start.fm Page 13 Friday, May 14, 2004 9:38 AM