JVC TK-C685E User Manual

28
Connection/Installation (TK-C685WPE/TK-C686WPE)
Mounting the Camera
1 Mount the fall prevention wire
● Mount the fall prevention wire of the camera to the fall
prevention wire anchor bolt that was installed earlier.
● Secure the fall prevention wire tightly with a nut and
washer.
2 Pull out the cables (from the wall) from the cable
connection hole
3 Mount the camera to the wall
● Mount the camera to the camera anchor bolts that were
installed earlier.
● Secure the camera tightly with a nut and washer.
Note :
● The mass of this product is approximately 5.5 kg. Pay
careful attention during mounting to prevent it from falling
off.
● For safety reasons, hold the arm during installation.
● After installing, paint the nuts and washers to prevent
corrosion.
Memo :
● To remove the camera, follow the reverse procedures.
Cable Connection
1 Connecting the coaxial cable (BNC)
A Lower the protection cover and connect the
connectors.
B After connection is complete, cover the connectors
with the protection cover.
C Wind the waterproof tape (cohesive) from the top of
the protection cover.
D Push the cables into the arm of the camera.
2 Connecting the power cable
A Connect the power cable.
B After the connection is complete, wind the waterproof
tape (cohesive).
C Push the cables into the arm of the camera.
Note :
● The AC 24 V power supply must be isolated from the
primary line. (ISOLATED POWER ONLY)
● In order to prevent an excessive current flow through the
power supply wire or camera due to a short circuit, a fuse
must be installed in the power supply line.
Camera Installation
Procedures (continued)
1
2
3
Fall Prevention
Wire
Washer
Nut
A B
C
D
C
Wind the waterproof tape (cohesive)
Protection
Cover
Arm
B
C
A
B
Wind the waterproof tape (cohesive)
Arm

JVC TK-C685E Specifications

General

Brand	JVC
Model	TK-C685E
Category	Security Camera
Language	English