12
Getting Started
Note :
● Set the TERM switch of CAM1 to ON, and terminate at the controller with a resistance of 110 K.
● Set the TERM switches of the other cameras to OFF.
● As long as there are no specifications, set PROTOCOL (2) to AOFFB. (A Page 19)
● An AC 24 V power source must be supplied to each camera.
System Connection
Example
:
Observe the following points when connecting
components together:
● Turn all the components off before proceeding.
● Read the instruction manuals of all components before
proceeding.
● For the types and lengths of connection cables, see
A Page 22 [Cable Connection](TK-C685E/TK-C686E)
A Page 32 [Cable Connection]
(TK-C685WPE/TK-C686WPE)
● Do not connect the control signal cables in a loop.
T TK-C685E/TK-C686E is used in the camera’s illustration.
To Next Page
Loading...
