JVC UX-A5 - Cassette Playback and Music Scan; Music Scan Feature Usage

UX-A5 A/B/E/G/GI/EN
CASSETTE PLAYBACK
Set to on.
Set to the TAPE mode.
Load a cassette with side A facing out.
Select the reverse mode( = / 32> / C2).
Set the DOLBY NR switch as required.
Press to start playback.
With automatic source selection, playback can be
started from the deck.
Operate in the order shown
@ When the tape is played back with the reverse mode set
tothe <= (single side play) or <> (both side play)
mode, the tape stops automatically at the end of tape
after playing one side or both sides.
MUSIC SCAN
@ The beginning of the current tune or the next tune can
be located using the music scan facility.
@ Press the > or <1 button for tape playback.
@ Press the > or << button for music scan.
e@ To the start of the next tune @ To the start of the tune being played back
(Forward ([>) direction playback)
(Reverse (<]) direction playback)
One of the two tape direction indicators blinks
during music scanning.
@ When music scanning is completed, playback will start
automatically.
© To skip two tunes or more, repeat the above steps @
and @.
Notes:
With the following types of tape, the Music Scan
mechanism may not operate correctly. This is not a
malfunction; use the Music Scan facility only with suitable
tapes.
® Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portion during tunes.
® Tapes with short non-recorded sections.
® Tapes with high-level noise or hum between tunes.
xiv