To Next PageTo Next Page
Need help?Do you have a question about the JVC UX-A5 and is the answer not in the manual?
Essential safety warnings for equipment design, maintenance, and critical components.
Identifies exothermic components in CD and Deck blocks for safety during service.
Overview of the JVC UX-A5's features, including its design and audio capabilities.
Detailed technical specifications for CD player, radio, tape deck, speakers, and general features.
Instructions for connecting and adjusting AM loop and FM antennas for optimal reception.
How to connect speaker cords and system units, ensuring correct polarity.
Identifies and explains the functions of various parts of the CD player/General section.
Details the functions of various cassette playback and control buttons.
Explains how to use the remote control unit, including its range and sensor operation.
Step-by-step guide to setting the current time on the unit, including notes on power failures.
How to adjust volume, bass, treble, and the Active Hyper-Bass function.
How to select, recall, and save preset or custom bass/treble patterns.
Steps for playing a CD, stopping, and automatic source selection.
Methods for navigating CD tracks via skip, search, and direct access.
How to program tunes, clear programs, and confirm playback order.
How to set single-tune or all-tunes repeat playback.
How to use the Music Scan feature to locate tunes during cassette playback.
Instructions for antenna connection and tuning to radio stations.
How to preset radio stations using the remote control unit.
Steps for CD edit recording, including tape length setting and spacing options.
How synchronized recording with a CD player works, including complete recording.
Recording from radio or external sources via AUX terminals.
Step-by-step guide for setting up timer recording for broadcasts.
How to cancel a set timer operation.
How to select the desired timer mode (Tuner, CD, Tape).
How to set the playback volume level for timer operations.
How volume is set and fades in during timer playback.
How to set the sleep timer for listening to audio sources.
Combining sleep timer function with timer playback for the next morning.
Identifies main components within the Deck/Power Supply section with diagrams.
Shows the layout of Amp/Power Supply, CD Unit, and Cassette Mechanism sections.
Identifies components like the front panel and LCD indicator on the CD/Tuner unit.
Step-by-step instructions for disassembling the CD/Tuner section of the unit.
Procedures for removing covers, front panel, and panel assembly parts.
Instructions for dismounting the entire CD player unit assembly.
Steps for dismounting the 3F (Microcomputer) and 2F (Tuner) P.C. boards.
Detailed procedures for changing the pickup, dismounting the CD door, and removing the clamper.
Procedure to separate the power supply section from the amplifier section.
Detailed steps for disassembling the main deck section components.
Instructions for dismounting the cassette door assembly and control switch board.
Step-by-step instructions for disassembling the power supply section.
Method for dismounting the speaker unit and speaker box, noting force application.
Detailed steps for disassembling the speaker box, including tool usage and boss removal.
Steps for dismounting the head mount and pinch roller assemblies.
Procedures for dismounting the FM bracket and capstan motor assembly.
Instructions for dismounting the actuator motor, flywheel, and drive motor assemblies.
Instructions for disengaging the cam switch board, control cam, and actuator gears.
Specifies measurement conditions and settings for the deck section.
How to adjust replay output level and tape speed using VR501.
Confirming L/R channels, head angle, tape speed, and replay characteristics.
Table listing preset frequencies for FM and MW bands with remarks.
Adjustment procedures for AM IF, FM IF, LW, MW, and FM tracking.
Confirmation steps for FM MPX, including stereo operation and frequency separation.
Procedure to adjust tracking offset by shaping the waveform to zero DC level.
Block diagrams illustrating the CD unit and overall signal paths.
Wiring diagrams for the front and rear sections of the unit.
Schematic for B/E/EN tuner circuit and layout of the tuner P.C. board.
Schematic for A version tuner circuit and layout of the tuner P.C. board.
Schematic for B/E/G/GI tuner circuit and component layout of the tuner P.C. board.
Component layouts for microprocessor, switch, motor, and LED boards.
Component layout of the CD amplifier P.C. board.
Schematic diagram for the CD amplifier circuit.
Component layout of the CD amplifier P.C. board.
Schematic diagram for the power supply and power amplifier circuit.
Component layouts for Relay Drive, Power Supply Relay, Power Amplifier, and Headphone Jack boards.
Schematic diagram for the cassette amplifier and control circuit.
Component layouts for Pre Amplifier, Signal Relay, Leaf Switch, Control Key, Reel Motor, and Cam Switch boards.
Schematic diagram for the function circuit, including controls and signal paths.
Component layouts for the Function, Aux Jack, and Volume boards.
Schematic for the CD key circuit and component layout of the CD key board.
Exploded view and parts list for the enclosure components of the Deck/Power Supply section.
Exploded view and parts list for the CD/Tuner section components.
Parts list for the speaker section, including cone speakers and terminals.
Exploded view of the cassette mechanism components.
Detailed list of parts for the cassette mechanism, including chassis, motors, and gears.
Exploded view of the CD mechanism components, including pickup and motors.
List of electrical components for the Tuner Board, including capacitors, inductors, and ICs.
Continuation of the Tuner Board parts list, including resistors, transistors, and IFTs.
Detailed list of electrical components for the CD Amplifier Board.
List of electrical components for the Power Amplifier and Supply Board.
Detailed list of electrical components for the Cassette Amplifier Board.
List of resistors for the Function Board.
Continuation of Function Board list, detailing transistors and VRs.
Further details on Function Board components, including capacitors and connectors.
Final part of the Function Board list, covering transistors, ICs, and coils.
List of parts for the CD/Tuner control board, including switches and resistors.
Continuation of control board list, detailing resistors and transistors.
Final part of the control board list, covering transistors, ICs, and switches.
List of resistors and transistors for the Function Board.
Continuation of Function Board list, detailing switches, ICs, and transistors.
Visual guide and list of parts for packing the product.
Detailed list of packing materials and components, including manuals and labels.
General
