JVC UX-A5 - Station Presetting Procedures; Presetting Radio Stations via Remote Control

Presetting stations
(using the remote control unit)
15 stations in each band (FM and AM) can be preset as
follows:
e Example (when presetting an FM station broadcasting
on 103.5 MHz to preset button "15")
Press
the
TUNER/BAND
button.
Select
the
FM
band
using
the
TUNER/BAND
button.
Tune
to
the
required
station.
Press
preset
button
"+10",
then
"5"
for
more
than
2
sec.
(When
"15"
blinks
in
the
preset
station
display,
the
station
has
been
preset.)
®
Repeat
the
above
procedure
for
each
of
the
other
stations,
using
a
different
preset
button
each
time..
@
Repeat
the
above
procedure
for
the
AM
band.
© To change preset stations
Perform
step
@
above
after
tuning
to
the
required
station.
Notes:
©
The
previous
preset
station
is
erased
when
a
new
station
is
preset
as
the
new
station's
frequency
replaces
the
previous
frequency
in
memory.
©
When
listening
to
an
AM
broadcast,
noise
may
be
heard
if
the
remote
control
is
used.
©
All
preset
stations
will
be
erased
when
the
power
cord
is
disconnected
or
a
power
failure
occurs
for
more
than
24
hours.
In
such
cases,
preset
them
again.
Preset
tuning
(using
the
remote
control
unit)
e
The
stations
must
be
preset
before
this
operation
can
be
performed.
@ Press the TUNER/BAND button
@
Select
the
band
(FM
or
AM)
using
the
TUNER/BAND
button.
@
Press
the
required
preset
station
buttons
(No.1
—No.10, +10).
@
The
preset
station
number
and
frequency
corresponding
to the button pressed are shown.
xvi
UX-A5 A/B/E/G/GI/EN
RECORDING
@ In recording, the ALC circuit automatically optimizes the
recording level; adjustment of the recording level is
unnecessary.
@ Check that the safety tab on the cassette tape is not
broken off.
CD edit recording (for CDs with up to 20 tunes)
e By checking the total playing time of the CD, a
microcomputer in the unit automatically calculates the
optimum length (recording time) of the tape to be used,
displays the required tape length, and divides the tunes
on the disc into two groups to be recorded on the two
sides of the tape so as to minimize tape waste.
Operate in the order shown
@ Press to open the CD door
@ Load a disc and press to close the CD door.
© Setto the CD mode.