JVC UX-A5 - Timer Mode and Volume Configuration; Selecting Timer Mode; Setting Playback Volume for Timer

© Select the TIMER mode.
Peal
a TIMER mode.
ENTER
® The selected timer mode
is shown in the display.
ey
UX-A5 A/B/E/G/GI/EN
When the UP button is pressed to select the timer
mode, the mode changes from the TUNER (timer
reception of a broadcast), CD (timer playback of a
CD), TAPE (timer playback of a tape), to
TUNER/REC (timer recording of a broadcast), in
this order.
TUNER
4
cD
4
TAPE
4 fs cl
TUNER vltk
gy
@ Set the volume.
— fs. i { ENTER
=) “pt i o> A
Sa This shows when volume LC
NY level 1 is selected. e Vis ealectad valuing weak
The playback level is determined by the position of
VOLUME control.
fs 4 = Ie ow} f (7 _4 cl Vs I a is / |
vom ov OL PPro © Kv oe a wv tn TF
Blinks
XY
ts cf €
~~ ry oe Tt
The volume decreases to zero at the timer start
time, and the sound fades in. (Volume level 5 is
approximately the same as when the VOLUME
control is set to its center position.)
© The unit enter the previously engaged mode
and timer setting is complete.
® To check the timer setting
1. Press the TIMER SET button.
2. Press the ENTER button to check the timer mode.
3. When the previous engaged mode is displayed, timer
setting has been completed.
Notes:
@ When the timer is set incorrectly or the correct mode is
not selected, perform “Setting the timer” from the
beginning.
@ When the timer is set, *-:--" in the display is replaced by
the input digits.
@ When the timer stop time is not set, the timer operates
for 2 hours and then the unit is switched off. To continue
listening after the timer stop time, display the timer stop
time, change the hours digits to "-:" using the UP button
and press the ENTER button.
XX