JVC UX-A5 - Timer Operation Setup Procedures; Setting Up Timer Recording; Cancelling Timer Operations

UX-AS A/B/E/G/GI/EN
Erasing
When recording on a pre-recorded tape, the previous
recording is automatically erased and only the new material
can be heard when the tape is played.
To erase a tape without making a new recording...
Press the @ (stop) button to set to the TAPE mode, then
perform recording.
Timer recording
@ The current time must be set correctly before you set
timer recording.
e@ Make sure that the erase protection tabs of the
cassette have not been broken off.
Operations
1. Set the POWER button to ON.
2. Load a cassette.
® Insert the cassette with the side to be recorded
facing out.
© Set the reverse mode buttonto” 2) "or" => *
and set the DOLBY NR button as required.
3. Set the timer start and stop times, set the timer
recording mode, then set the required volume, in this
order. (Refer to "Setting the timer” on page 50)
@ Set the timer about a minute before the broadcast to
be recorded is scheduled to start.
© Set the TIMER mode button to TIMER/TUNER [REC].
4. Tune to the station to be recorded. (Refer to page 38. )
5. Set the POWER button to STANDBY.
© Timer recording will start at preset start time and
the power will be switched off at preset stop time.
When timer recording is completed, the timer mode is
switched to the “TUNER” (timer reception of broadcast)
mode.
® To cancel timer operation
Press the TIMER ON/OFF button so that the timer mode
display goes out
If you do this, timer recording will not start at the timer start
time.
Notes:
Once the timer has been set, the start and stop times,
etc., are stored in memory. When timer recording or
playback is required at different times, the timer must be
set again.
© After setting the timer start and stop times, check that
the unit is tuned to the required frequency.
@ When the power cord is disconnected or there is a power
failure, timer settings will be erased from memory. If this
happens, set the current time and perform the timer
setting again.
Setting the timer
e
The
current
time
must
be
set
before
the
timer
can
be
used.
@ Press the TIMER SET button.
Blinks
TIMER ‘
ON
A”
so
@ Set the start time
(Example: when the timer start time is set to 12:15.)
@ Adjust the hours.
ENTER
@ Adjust the minutes.
Blinks ‘A (OFF
ea
-!
a
is
=
~~
! : t ENTER
ne
ir
a
ee
taal
|
U : )
f : J
— L
| ® Press to set the start time.
© Set the stop time
(Example:
when
the
timer
stop
time
is
set
to
13:15.)
@® Adjust the hours.
Y = So ot
EWTER
Ly
@ Adjust the minutes.
=>
Blinks
ENTER
|.
|
Destella
td 5
— Chr
! aE a
fad El
@ Press to set the timer off time.
xix