JVC UX-A5 - CD Mechanism Disassembly Procedures; Pickup, CD Door, and Clamper Removal Steps

UX-AS A/B/E/G/GI/EN
<CD Unit Section>
1. Remove the three screws ‘© retaining the CD P.C. fl e+ (11)
board
ass’y.
>
~
2.
From
the
CD
motor
ass’y,
dismount
the
connector
—
1¢602
provided
from
the
CD
P.C.
board
to
the
motor
P.C.
board
1C603
1c605
(In this case, the pickup P.C. board connector should also
be dismounted as necessary).
3. Remove the two screws @ retaining the CD
mechanism ass’y.
4. Raise the CD mechanism from the motor side and
dismount the mechanism while pushing the rubber
cushion E section downward.
H@ Pickup Changing Method
1. Place the turntable of the mechanism ass’y while keeping
the table upside, and remove the two screws
retaining the pickup cover (black).
2. Remove the two screws (14) retaining the plastic
controller, and unlock the section F.
3. Now, it is possible to dismount the pickup shaft and
change the pickup.
@ CD Door Dismounting Method
1. Dismount the CD door open sensor P.C. board.
2. Dismount and pull out the CD door shaft.
Mechanism
Holder
@ CD Clamper Dismounting Method
1. Under the conditions wherein the CD door is opened and
the clamper is drawn to the front side of the door, pull
the back side of the door. Next, slide the clamper to the
back side of the door where the click has been
disengaged. then, the clamper can be dismounted.
(No. 1857) 7