JVC UX-A5 - Tape Deck and Amp. Section Disassembly; Separating Power Supply and Amp. Sections

UX-A5 A/B/E/G/GI/EN
<Procedures for Disassembly of the Tape Deck and Amp. Section>
Remove the six screws (1) retaining the upper cover. Buwersutaly pn ekeam
EAE ex Dente Relay drive P.C. board
H Separation of Power Supply Section and
Amp. Section
. Dismount the P.C. board holder.
2. Remove the pin 9 of the power supply wire from the
preamp. P.C. board CN609.
3. Remove the head phone wire from the relay P.C. board
CN355 (See Fig. 5-13).
4. Remove the pin 5 of power supply wire from the preamp.
P.C. board CN302.
5. Remove the two screws @) clamping the bottom cover
and front panel.
6. Then, the power supply section and amp. section can Cassette key switch P.C. board
be
separated.
Head
phone
P.C.
board
=
mechanism
coantrol
1 P.C. board ~~
Power supply trans.
P.C. board
Fig. 5-11
f <
\
w f°} ® a Zz ° a 2
Mounting screw
of chassis
Fig. 5-13
8 (No. 1857)