JVC UX-A5 - Sleep Timer Functions and Usage; Sleep Listening Mode Setup; Sleep Mode with Timer Playback Combination

@ When the power is switched on, it is possible to fade in
the sound from volume level 0 (zero) to the preset vol-
ume.
® To cancel timer operation
Press the TIMER ON/OFF button so that the timer mode
display disappears. (To set to the timer mode again,
press the TIMER ON/OFF button twice so that the timer
mode display appears.)
SLEEP OPERATIONS
A. Use this when you want to fall asleep while
listening to CD, a tape or broadcast.
©® Set to the required source
@ Press the SLEEP button to set to the sleep time.
SLEEP
f Y SLEEP] is shown in the display E>
© Sleep times of 30, 60, 90 or 120 minutes can be set. When
you release the SLEEP button, the source is displayed after
10 sec.
@ The sleep operation will start and the power will be
switched off after the specified time.
@ Checking the sleep time
When the SLEEP button is pressed, the remaining sleep
time is displayed. If it is pressed again, a new sleep time
can be set.
e To cancel the sleep operation
Press the POWER button to switch the power off.
B. To fall asleep while listening to CD or a
broadcast and to perform timer playback the
following morning.
1. Set the timer playback start and stop times.
2. Set the timer mode and volume.
3. Set to the required source (CD, tape or broadcast).
4. Press the SLEEP button to set the sieep time.
@ Any required source can be selected when performing
the sleep operation and time playback. For example;
« CD play for sleep operation and broadcast reception
for timer playback.
« Tape playback for sleep operation and CD play for
timer playback.
However, when broadcast reception is selected for both
sleep operation and timer playback, the station you
were listening to at night will be tuned to the following
morning.
SLeeP
ai
Tape playback
UX-A5 A/B/E/G/GI/EN
Notes:
@ When the volume setting is set to “VoL -" (volume level
is not specified), the timer playback volume is set to
that before setting the timer.
© To stop during timer playback, press the POWER button
to switch the unit off.
e In the fade-in mode, the volume gradually increases
from zero.
Load a disc and press the >1f button to play the disc.
Load a cassette and press the [ or <J button to play
back the tape.
Press the TUNER/BAND button to set to the tuner
mode and tune to the required frequency.
tart
1 5 mam
i Oo oe fei
Source mode display (Releasing the sleep mode)
> |
m1 Tf mel 7m
m6 SU le ua |
Source mode display (Releasing the sleep mode)
!