UX-A7DVD
(No.22013)1-25
2.3.6 Removing the motor assembly
(See Fig.9, 10)
• Prior to performing the following procedure, remove the
clamper assembly, the tray, the servo control board, the
traverse mechanism assembly and the elevator.
(1) Remove the belt from the pulley.
(2) Remove the screw C attaching the loading motor.
(3) Remove the screw D attaching the motor board on the
back of the loading assembly.
(4) Release the tab i fixing the motor board and remove the
motor assembly.
Fig.9
Fig.10
C
Loading motor pulley
Belt
Loading assembly
Motor board
Motor assembly
D
Tab i
To Next Page
Loading...
Need help?
General
