18
Auto Scan
The auto scan will search for the entire DAB Band III channels. After the scan has nished,
the rst alphanumerically found station will be automatically selected.
1. Press SCAN/A-B to activate automatic program mode. The display will show
“SCANNING” that indicates the progress of the scan and the amount of stations that
have been found so far.
2. Once the scan has nished, the unit will display the total number of stations have
been found and a list of the found stations. All stations that have been found will be
automatically stored.
Manual Tuning
As well as the auto tune function, you can manually tune the receiver. This can help you
when aligning your aerial or when adding stations that were missed while auto tuning.
1. Press and hold the button to select Manual tune, the display will now show “Manual
tune”.
2. Press / to cycle through the DAB channels, which are numbered from 5A to 13F.
3. After your desired channel number is selected, press the button to conrm, display
will now show the frequency. The unit will start to scan.
Secondary Services
You may see a “>” symbol after the name of the station, this indicates that there are
secondary services available to that station. These secondary services contain extra
services that are related to the primary station. e.g. a sports station may want to add extra
commentaries. The secondary services are inserted directly after the primary station in the
station list.
To select the secondary station, press / until you nd the secondary service you
want, then press to select it.
When the secondary service ends, the unit will automatically switch back to the primary
station.
Presetting Stations
You can store up to 30 of your favourite stations to the memory. This will enable you to
access your favourite stations quickly and easily.
1. To store a preset, you must rst be listening to the station that you would like to save.
2. Press PROGRAM to activate program mode. The preset number “P##” will blink.
3. Press ALBUM/PRESET / to select the desired station preset number.
4. Press PROGRAM again to store the station, the display will show “P##SAVED”.
Recalling a Preset Station
Once you have saved a station, you can recall a preset station by pressing ALBUM/PRESET
/ .
To Next Page
Loading...
Need help?
General
