20
Manual Tuning
Press / repeatedly to change the frequency until you nd the station you want.
FM Radio Operation
• Make sure that you have correctly connected and fully extended the antenna.
• The search may not stop at a station with a very weak signal.
• If reception is still poor, try to adjust the DAB / FM aerial location.
The search may not stop at a station with a very weak signal.
With FM radio it may be necessary to ne tune each station by pressing / repeatedly. Each press
will adjust the frequency by 0.05MHz. If reception is still poor adjust the position of the aerial or try
moving the radio to another location.
Turn SOURCE dial on the unit or press FM/DAB button repeatedly on the remote control to
select the tuner source. The word “TUNER” will be showed on the display.
Tuning in a Station
Auto Tuning
Press and hold / for a few seconds, the frequency changes down or up automatically
until a station is found.
Preset Tuning
After the stations are preset (for details, please refers to the section “Presetting Stations”
below), repeatedly press the ALBUM/PRESET / buttons on the remote control to select
the desired preset number. Its band and frequency are displayed on the front panel.
Presetting Stations
You can store up to 20 of your favourite stations to the memory. This will enable you to
access your favourite stations quickly and easily.
Automatically
Press and hold PROGRAM for a few seconds. The word ‘SCANNING’ will briey appear on
the display. The unit will automatically search and store the rst 20 radio stations it nds.
Manually
1. Tune into a desired radio station as shown above.
2. Press PROGRAM to activate program mode. The preset number will ash in the display.
3. Press ALBUM/PRESET / to select the programme position number (1-20).
4. Press PROGRAM again to store the station.
To Next Page
Loading...
Need help?
General
