JVC UX-G28

13
Setting the Clock
Without setting the built-in clock, you cannot use the Daily
Timer (see page 17).
1 Turn off (standby)
2 Activate the clock setting mode.
3 Adjust the hour.
4 Adjust the minute.
The built-in clock starts working.
To check the current time during play
Display clock a few seconds and back to source.
If there is a power failure
The clock loses its settings and blinks. You need to set the
clock again.
Turning Off the Power Automatically
To turn off the System after a certain period of
time—Sleep Timer
1 Activate the sleep timer mode.
2 Specify the time (in minutes).
• Sleep timer requires a few seconds to set. The system
automatically turns off when the selected count down
time is executed.
To check the time remaining until the shut-off time
CLOCK/
SLEEP
SLEEP
REPEAT1
TRACK WMA
GROUP
HBS JAZZ
5 sec.
CLOCK/
SLEEP
CLOCK/
SLEEP
CLOCK/
SLEEP
CLOCK/
SLEEP
2 sec.
CLOCK/
SLEEP
(Canceled)
OFF
10
20
30
40
50
60
70
80
90
CLOCK/
SLEEP
SLEEP
2 sec.
UX-G28[J].BOOK Page 13 Monday, November 12, 2007 10:49 AM