JVC UX-G49 - Daily Timer Operations; Setting Up Daily Timers

29
Daily Timer Operations
Setting the Daily Timer
Using Daily Timer, you can wake up with your favorite
music.
You can store three Daily Timer settings; however, you can
activate only one of the timers at any one time.
• To exit the timer settings, press CLOCK/TIMER (while
holding SHIFT) as required.
• To correct a mis-entry during process, press CANCEL
(while holding SHIFT). You can go back to the previous
step.
1 Select one of the timer setting modes you want to set—
DAILY 1 ON time, DAILY 2 ON time, or DAILY 3
ON time.
• When the clock has not been set, pressing CLOCK/
TIMER (while holding SHIFT) makes the System enter
the clock setting mode (see page 15).
2 Set the timer as you like.
Repeat the procedure for the following settings until
finished.
ENTER/SET
AUDIO
CLOCK/TIMER
,
SHIFT
CANCEL
Remote control
Initial Daily Timer settings when shipped from the
factory:
• DAILY 1: ON Time (6:00)/OFF Time (8:00)/Source
(TUNER FM 1)/Volume level (– –)
• DAILY 2: ON Time (7:00)/OFF Time (9:00)/Source
(TUNER FM 1)/Volume level (– –)
• DAILY 3: ON Time (10:00)/OFF Time (12:00)/Source
(TUNER FM 1)/Volume level (– –)
Remote
ONLY
INFO
CLOCK/TIMER
6
Ex. When Daily Timer 1 setting mode is selected
Clock setting
(see page 15)
DAILY 1
ON (Time)
Daily Timer 1
DAILY 2
ON (Time)
Daily Timer 2
DAILY 3
ON (Time)
Daily Timer 3
Canceled
(while holding...)
PTY PTY
ENTER/SET
UX-G48[B].book Page 29 Friday, June 22, 2007 11:28 AM