JVC UX-P3 - Removing the Tuner Board; Removing the CD Mechanism Assembly

1-8
UX-P3
Prior to performing the following procedure, remove
the metal cover.
Disconnect the card wire from connector CN1 on the
tuner board.
Remove the screw D on the right side of the body.
Remove the two screws E on the rear panel.
1.
2.
3.
Removing the tuner board
(See Fig.4 and 5)
Prior to performing the following procedure, remove
the metal cover and the rear cover.
Disconnect the card wires from connector CN903,
CN904 on the main board on the upper side of the
body.
Remove the screw D attaching the tuner board and
the CD mechanism on the right side of the body.
Remove the two screws F attaching the rear panel
and the CD mechanism on the back of the body.
Move the rear part of the CD mechanism assembly
upwards to disengage the two joints a and release
from the rear panel.
Pull the front panel toward the front and move the
rear part of the CD mechanism assembly upwards.
Then pull out the CD mechanism assembly from the
front panel backward.
1.
2.
3.
4.
Removing the CD mechanism assembly
(See Fig.6 to 8)
To remove the CD mechanism assembly
efficiently, disconnect the card
wireconnecting the tuner board with the
main board in advance.
REFERENCE:
Fig.4
Fig.5
Fig.6
Fig.7
D
CN1
Tuner board
E
Rear cover
Rear panel
Rear panel
Tuner board
Card wires
CD mechanism assembly
Front panel assembly
CN903
Main board
CN904
CD mechanism assembly
Tuner board
D
Front panel assembly