JVC UX-P400

1-30 (No.MB262)
SECTION 4
ADJUSTMENT
4.1 Jigs and test instruments
• Remote controller
4.2 Adjustment and check method
4.2.1 Initialize all data to the factory setting
4.2.2 Confirmation of the system micro computer
4.2.3 FL all lighting-up check
4.2.4 Fan motor ON/OFF check
Initialize is complete.
Pressing the [STOP] , [SLEEP] and
[STANDBY/ON] together at Power
ON condition.
FL indication
COLD
Pressing the [STOP] , [SLEEP] and
[STANDBY/ON] together at Power
ON condition.
Setup is complete.
FL indication
08 02 E
or
09 00 E
Pressing the [STOP] , [SLEEP] and
[STANDBY/ON] together at Power
ON condition.
Setup is complete.
FL indication
All of the FL displays light up.
Pressing the [STOP] , [SLEEP] and
[STANDBY/ON] together at Power
ON condition.
Setup is complete.
Fan motor is rotating.