– 10 –
Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich (“AHB 1”
and “AHB 2”), full bass at low volume. This function only
affects the playback sound, but does not affect your
recording.
To get the effect, press AHB (Active Hyper
Bass) PRO until “AHB 1” or “AHB 2” appears
on the display. The BASS indicator also lights
up on the display.
• Each time you press the button, the bass sound change as
follows:
“AHB 2” has much more bass reinforcement effect than
“AHB 1.”
To cancel the effect, press AHB PRO until “AHB OFF”
appears on the display. The BASS indicator goes off.
Selecting the Sound Modes
You can select one of the 4 preset sound modes. This function
only affects the playback sound, but does not affect your
recording.
To select the sound modes, press
SOUND MODE on the remote control (or
SOUND on the unit) until the sound mode you
want appears on the display. The SOUND
indicator also lights up on the display.
• Each time you press the button, the sound modes change as
follows:
ROCK: Gives a heavy sound. Boosts low and high
frequency.
POP: Good for vocal music.
CLASSIC: Good for classical music.
JAZZ: Gives a feeling of live atmosphere. Good for
acoustic music.
FLAT: The sound mode is canceled. The SOUND
indicator goes off.
Adjusting the Volume
You can adjust the volume level only while the unit is turned
on. The volume level can be adjusted between “VOLUME 0”
and “VOLUME 40.”
When using the remote control, press
VOLUME + to increase the volume or press
VOLUME – to decrease it.
When using the unit, turn VOLUME + / –
clockwise (+) to increase the volume or
counterclockwise (–) to decrease it.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, a
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source next time.
REMEMBER you cannot adjust the volume level
while the unit is on standby.
Selecting the Display Brightness
You can change the display brightness only while the unit is
turned on.
To change the display brightness, press
DIMMER on the remote control.
• Each time you press the button, the display
dims and brightens alternately.
BASS
SOUND
FLAT
(Canceled)
ROCK POP
CLASSICJAZZ
AHB
PRO
VOLUME
SOUND
MODE
VOLUME
–
+
SOUND
DIMMER
AHB OFF
(Canceled)
AHB 1
AHB 2
EN01-13_UX-P55[B]f.pm6 03.1.23, 7:55 PM10
To Next Page
Loading...
Need help?
General
