(No.MB230)1-37
4.7 Confirming method of DVD region
(1) Press "STANDBY/ON" key of the main body to turn it on.
(2) Push both "B.SKIP" key and "DVD/CD" key of the main body.
NOTE:
Confirming DVD region is effective only when source is DVD mode.
(3) DVD region confirm mode set up, and DVD region is displayed temporarily on FL display for 5 seconds.
NOTE:
If there is no information feedback, SYS-CON will display "WAIT" blinking 0.5 second ON & OFF.
(4) FL display will display "AREAxxRy" where "AREAxx" is the destination information & R is the region information.
(5) After 5 seconds, return to previous display.
4.8 Displaying of micon version
(1) Press "STANDBY/ON" key of the main body to turn it on.
(2) Push "STANDBY/ON" key, "ENTER" key and "9" key of the remote controller.
NOTE:
Displaying of micon version is effective only when source is DVD mode.
(3) Micon version is displayed temporarily on FL display for 5 seconds.
NOTE:
If there is no information feedback, SYS-CON will display "WAIT" blinking 0.5 second ON & OFF.
(4) Each "STANDBY/ON" key, "ENTER" key and "9" key of the remote controller press, change the display as follows.
(5) After 5 seconds, return to previous display.
4.9 Display of tuner version
(1) Press "STANDBY/ON" key of the main body to turn it on.
(2) Push "STANDBY/ON" key, "ENTER" key and "1" key of the remote controller.
(3) Tuner version is displayed temporarily on FL display for 5 seconds.
(4) After 5 seconds, return to previous display.
------------ Syscon version
FL Display (Example)
C2308 - R0
------------ DVD LSI (BE) version
WA I T
------------ DVD Mecha version
35 0258
0 V J C ------------ For JC
1 V E _ R D S ------------ For E RDS
2 V A ------------ For A
3 V U S 9 K ------------ For US9K
4 V U S 1 0 K ------------ For US10K
6 V U X 1 0 K ------------ For UX10K
7 V U W 9 K ------------ For UW9K
8 V U W 1 0 K ------------ For UW10K
9 V U F 9 K ------------ For UF9K
A V U F 1 0 K ------------ For UF10K
5 V U X 9 K ------------ For UX9K
To Next Page
Loading...
Need help?
General
