STANDBY/ON indicator
PHONES
DIMMER
DISPLAY
AHB PRO
BASS
TREBLE
VOLUME+,–
REMOTE CONTROL RM-RXUV3
DIMMER SLEEP
DISPLAY FM MODE MD/AUX
AHB PRO
AUTO
PRESET
CD
PROGRAM RANDOM REPEAT
BASS TREBLE CANCEL
UP
SET
DOWN
TUNER
BAND
TAPE
VOLUME
CD
VOLUME
AUTO TAPE SELECTOR
CLOCKREV.MODE SLEEP
TIMER/
SNOOZE
REC
AHB PRO
AUTO REVERSE
CLOCK
VOLUME+,–
AHB PRO
Turning the System On ——————
Press the button.
The display comes on and “HELLO” is displayed once. The STAND-
BY/ON indicator lights in green.
The System comes on ready to continue in the mode it was in when
the power was last turned off.
■
For example, if the last thing you were doing was listening to a
CD, you are now ready to listen to a CD again. If you wish, you
can change to another source.
■
If you were listening to the Tuner last, the Tuner comes on playing
the station it was last set to.
Turning the System Off ——————
Press the button again.
“GOOD BYE” is displayed and the display goes out, except for the
clock display. The STANDBY/ON indicator lights in red.
■
Some power is always consumed even though power is turned off
(called Standby Mode).
■
To switch off the System completely, unplug the AC power cord
from the wall outlet. When you unplug the AC power cord, the
clock will be reset to 0:00 after about 20 minutes.
You can adjust the brightness of the backlighting for the display.
When the System is Turned On ——
To make the brightness of the backlighting darker, press the
DIMMER button on the Remote Control.
To make the brightness brighter, press the DIMMER button on
the Remote Control again.
When the System is Turned Off
(STANDBY MODE) —————————
To turn on the backlighting, press the DIMMER button on the
Remote Control. The brightness is the same as for darker one men-
tioned above.
To turn off the backlighting, press the DIMMER button on the
Remote Control again.
Press the VOLUME + button to increase the volume or press the
VOLUME – button to decrease it.
You can adjust the volume level between 0 and 50.
CAUTION: DO NOT turn on the System and/or start
playing any source without first setting the VOL-
UME control to minimum, as a sudden blast of
sound could damage your hearing, speakers and/or
headphones.
For private listening
Connect a pair of headphones to the PHONES jack. No sound comes
out of the speakers.
Be sure to turn down the volume before connecting or putting on head-
phones.
Turning the Power On and Off
Adjusting the Brightness
(DIMMER)
Adjusting the Volume
To Next Page
Loading...
Need help?
General
