EasyManuals Logo

JVC XV-M565BK Service Manual

JVC XV-M565BK
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
XV-M565BK/M567GD
1-22
(4) Focus ON NG
* Is FE output ? --- Pattern, IC101
* Is FODRV signal sent ? (R288) --- Pattern, IC201
* Is driving voltage sent ?
CN102 "9", "11" --- If NG, pattern, driver, mechanical unit (with the power turned off, measure the
resistance between CN102 "9" and "11").
* Does CN101 "14"(SRF1) become "H" and is the focus drawing in done?
--- Mechanical unit (laser power too low), IC101(defective gain)
--- Moreover, It is thought that abnormality is found in the disk.
* Mechanical unit is defective.
(5) Tracking ON NG
* When the tracking loop cannot be drawn in, IC201 "58" (/TRON) does not become "L".
* Mechanical unit is defective.
Because the undermentioned adjustment value is abnormal, it is not possible to draw in normally.
* Periphery of driver (IC271)
Constant or IC it self is defective.
(When passing without becoming abnormal while adjusting the following.)
* Servo IC (IC201)
When improperly adjusted due to defective IC.
[Focus position rough adjustment]
[Phase difference cancellation rough adjustment]
[Tracking balance adjustment]
(6) Spindle CLV NG
* When the spindle cannot be shifted to CLV Servo, does not become "H" between IC301 "88"
and IC201"18".
* IC101 Is signal output from CN104 "1" (RFOP)?
* IC101 Is signal output from CN104 "12" (FLTOUT)?
* IC101 Is signal output from CN104 "7" "8" "9" "10" (binary-coded clock and data)?
* IC201 Is "58" (/TRON) at "L" level ?
* Besides the causes mentioned below, it is difficult to point out a specific one because there are various
factors that should be considered.
Mechanism is defective.(jitter)
IC101, IC201.
* Besides the causes mentioned below, it is difficult to point out a specific one because there are various
factors that should be considered.
Mechanism is defective. (jitter)
IC201, IC301, IC401.
The disc is dirty or the wound has adhered.
(7) Address read NG
(8) Between layers jump NG (double-layer disc only)
* Defective mechanism
* The ICs surrounding the driver IC (IC271) are defective.
* Servo IC (IC201) is defective.

Other manuals for JVC XV-M565BK

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC XV-M565BK and is the answer not in the manual?

JVC XV-M565BK Specifications

General IconGeneral
BrandJVC
ModelXV-M565BK
CategoryDVD Player
LanguageEnglish

Related product manuals