EasyManua.ls Logo

K-9 BSD BSD-4 - Pairing and Control; Transmitter-Launcher Pairing; Loading the Reward Launcher

K-9 BSD BSD-4
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Pairing the transmitter with the reward launcher
Each transmitter has its radio operating codes. The transmitter communicates with
your reward launcher only after mutual pairing. When buying a new set, the
transmitter is paired with the reward launcher. Pairing is necessary if you want to
pair other reward launchers or ball droppers with your transmitter. Reward
launchers and droppers can combined on one remote.
Important: Before pairing the transmitter and launcher, make sure that no one else uses
his/her reward launcher or ball dropper in your vicinity. Your reward launcher could
receive the code of another transmitter. Your reward launcher would then be controlled by
someone else. If this happens, pair your reward launcher with your transmitter.
1. Place the reward on the launching bowl
2. Push the reward by your palm to the bottom of the reward launcher
3. If you have a BSD-4 with barrel, insert a ball or large Kong upside down into the
barrel and push down on the ball or Kong with the supplied cocking stick.
CAUTION: Load the reward launcher with rewards only. Do not insert your
fingers or other part of the body into the loaded reward launcher – this may
cause serious injury. The reward launcher can be operated only by persons over
18 years of age.
Pairing procedure
Switch off the reward launcher before starting pairing (no indicator flashes).
Do not load the reward launcher before pairing – risk of injury.
Attach the bottom side of the transmitter between the red target and the clear LED
window on the bottom side of the reward launcher for 5 seconds. The red
indicator and then the green indicator will turn on.
2. After 5 seconds, both indicators will flash three times at the same time.
3. Take the transmitter away from the reward launcher.
4. Press the tone signal button on the transmitter (position 1 to 4 depending on
which position you want to pair with the given reward launcher).
5. Successful pairing is indicated by a long beep of the reward launcher.
K-9 BSD-4 Control
Loading the reward launcher
8