16 17
3
Press the button for the required cup
size for at least 3 seconds to activate
programming. Release the button. The
cup will now be filled up with the drink.
Stop the brewing process by pressing the
button again once the required filling
quantity has been reached. This new
setting will be saved automatically.
1
Switch the appliance on and place the
required cup under the spout.
2
Open the lever and insert the required
capsule. Now close the lever completely
again.
1
Allow the appliance to go into the
automatic o/standby mode (automatic
switch-o 5 minutes after last use).
2
Now press the "Small cup" button
and the milk button simultaneously,
and keep the buttons pressed for at
least 3 seconds. Release the button.
Both buttons will blink briefly once to
confirm resetting to factory settings.
Buttons
30 - 100
80 - 200
/
45
105
65
setting range
[ml]
factory setting
[ml]
PROHIBITED Do not reach
inside – injury hazard.
WARNING Very hot water –
scalding hazard.
NOTE It is possible to reset
the appliance to the factory
settings (see P. 17).
INFO
Resetting the appliance to
the factory settings deletes
your individual settings for
cup capacity.
INFO
The factory setting is 5 minutes in order to avoid unnecessary energy
consumption and to protect the environment. This means that the
appliance automatically switches itself o after 5 minutes of non-use. This means that
your K-fee® – your system capsule machine uses considerably less energy: the applian-
ce consumes considerably less power (less than 0.5 W) than it does in operating mode.
During periods of absence and at the end of the brewing day, switch the appliance
o at power supply (240 V plug).
Stop
3
min.
3 sec.
2
2
min. 3 sec.
English
Programming cup capacity Resetting to factory settings
To Next Page
Loading...
