K. O. LEE B6062 - Tool and Cutter Grinders; Machine Standard Equipment; Tooling and Fixtures and Accessories; Workheads for Model Series

Instruction Manual Section Six
II. MACHINE STANDARD EQUIPMENT
B. TOOL AND CUTTER GRINDERS
MODELS B300, BA900, B2000
A609A T-Slot Arm, A657 T-Slot Bolt (4), A660 T-Slot Bolt (2), B246C Wheel Guard 4", B246D Wheel
Guard 6", B628 Wrench, B640K Diamond Dresser, B827 Plain Tooth Rest, B855W Wrench, B922
Tailstocks (Matched Set) with two A258 T-Slot Bolts, B923C Motor Assembly, B939 Center Gauge,
BA940 Universal Tooth Rest (B940H Micrometer Tooth Rest. Blades: B240D, B240DS, B240DT, B940HF),
E1 Wheel Dresser, CV4NM60 Cup Wheel, PV6CH60 Straight Wheel, SV6GM60 Saucer Wheel.
C. ADDITIONAL STANDARD EQUIPMENT FOR HYDRAULIC MACHINES
S89l Extension Wrench for Stop and Reversing Screws.
III. TOOLING, FIXTURES AND ACCESSORIES
A. WORKHEADS FOR MODEL SERIES B300, B360, BA9C0, BA960, BA962, B2000,
B2060, B2062:
B942 Sensitive Workhead with No. 11I B&S Spindle Taper, B942XM Sensitive
Workhead with No. 5 Morse Spindle Taper, B942XB Sensitive Workhead with
No, 12 B&S Spindle Taper, B942XB11 Sensitive Workhead with No. 11 B&S
Spindle Taper (Index Disc mounted at rear. Uses B641 Collet Fixture with
5C Collets), B992 Large Sensitive Workhead with No. 50MM Spindle Taper
(B792F No. 50MM to 40MM Adapter Sleeve, B792C No. 50MM to No. 11
B&S Adapter Sleeve), B943 Motor (A.C.) Driven Workhead with No. 11 B&S
Spindle Taper, B943M5 Motor (A.C.) Driven Workhead with No. 5 Morse
Spindle Taper, B943B12 Motor (A.C.) Driven Workhead with No. 12 B&S
Spindle Taper, B2043 Variable Speed (@ 25-425 RPM) Motor (D.C.) Driven
—99—