Kaba 1000 Series - User Manual

Access Control - 1000 Series PBL FAQ
Note: If your lock is opening on every turn of the knob or lever, except upon entering a code,
this may be a ZERO CODE. Before attempting to remove the lock from the door, refer to the
troubleshooting procedures outlined at bottom of this document for a zero code
symptom/solution.
1000 Series FAQ
Changing the Code / Combination
The door must be open.
On models with the passage feature, make sure the passage feature is disengaged: turn knob
or key should be in vertical position (A) (see figure 1).
http://www.kaba-ilco.com/access_control/support/pbl_faq/changing_code_combination/1000_series.asp (1 of 3) [5/21/2004 11:13:59 AM]

Summary

Changing the Code; Combination

Preparation: Door Open and Passage Feature Disengaged

Ensure the door is open and the passage feature is disengaged by setting the knob or key to vertical position.

Procedure Steps for Combination Change

Detailed steps involving a control key, spanner wrench, and entering the existing or factory-set combination to set a new one.

Troubleshooting Zero Code Symptom

Symptom: Knob Retracts Latch Without Buttons

The outside knob retracts the latch without needing to press any buttons.

Cause and Solution for Zero Combination

Lock is in zero combination; omit step 3 (entering existing combination) when changing.

Kaba 1000 Series Specifications