MegaTimer™ Instruction Manual
Kagan Publishing • (800) 933-2667 • www.KaganOnline.com
6
Powering Up
Batteries
Battery operation requires 6 AA batteries.
You may use 6 AA batteries or a power adapter to power up your
MegaTimer. Please refer to the Batteries or Power Adapter section
for proper use.
To Insert Batteries
1. Press up on the tab of the battery door to remove the battery door.
2. Insert 6 AA batteries, 3 per row. Be careful to match the + and – ends of
the batteries to the + and – indicated on the back of the MegaTimer (see
diagram below).
3. Replace the battery door.
Battery Installation Diagram
• Batteries should be installed and removed by an adult only.
• Do not dispose of batteries in fire. Batteries may explode or leak.
• Install batteries with the correct polarity (+ and –).
• Do not mix batteries (old and new; alkaline, standard, rechargeable; type).
• Do not attempt to recharge nonrechargeable batteries.
• To avoid leakage, remove batteries if not using for a long period.
• Replace the batteries at first sign of incorrect operation.
Important Battery Information
Battery Saving Tips
• Turn off the display when not in use.
• Backlight is not recommended for battery use;
use a power adapter when using the backlight.
• Use a power adapter instead of batteries
unless mobile use is required.