Kaiser Baas REVO E1 - How to Ride; Getting Started and Acceleration; Braking and Stopping Procedures

HOW TO RIDE YOUR E1 E-SCOOTER
17 - ENG
Warning:WhileusingyourE-Scooter,
there is always a risk of falling. We highly
recommendyoualwayswearacertied
safety helmet.
1. Turn on the E-Scooter by pressing the
Power button for 3 seconds. Check the
battery power.
2. Oncethepowerison,liftthekickstand,
place one foot on the deck and one foot on
the ground.
The E-Scooter is push to start so you need
toreachaminimumof6km/hbeforethe
accelerator will start working.
Pushousingyourfootonthegroundto
reachaspeedofover6km/h.
You can push the accelerator and when
you feel safe place both feet on the deck.
Push the accelerator button to increase the
speed of your E-Scooter.
Accelerator
1
2
HOW TO RIDE YOUR E1 E-SCOOTER
18 - ENG
3. Tostopriding,releasethethrottleand
use the electric brake to gradually coast
toastopthenstepotheE-Scooterone
foot at a time. Be extra cautious when
dismountingforthersttime.
Warning: The E-Scooter has both an
electric brake and physical rear fender
brake,theelectricbrakeshouldbeused
rst.Therearfenderbrakeshouldonlybe
used as an auxiliary brake as an additional
safety precaution.
Inanemergencysituationyoucanuse
both the electric brake and rear brake at
the same time.
DONOTstepontherearbrakeforalong
time as it could damage the tyre or fender.
4.TurnotheE-Scooterwhenyouhave
nishedusingitbypressingthepower
button for 3 seconds.
3
4