Loop Recording
This allows you to record continuously using footage intervals of 2/3/5 minutes. The
camera will delete the oldest loop recording file and replace with the latest
recording when the MicroSD is full.
Dual files
This mode enables the camera to save two videos simultaneously when recording
video. It will record the default resolution option and a smaller video file. The
following chart is an example of how this mode functions.
Audio Recording
Set the microphone recording level to the following intervals Off/50%/75%/100%.
By default, audio recording is set to 100% On.
Auto DVR
Auto DVR or Car Mode lets you use the X4 camera like a Dash Camera and record
in Loop Mode.
When enabled the X4 will begin recording the moment a power input/source has
been detected.
When the power source has been shut off/disconnected the camera will record for
an interval (see delay section) and then shut off.
Delay Off
The Delay Off setting is only enabled when in Auto DVR mode.
It lets you configure how long the camera remains recording after the power source
has been disconnected.
Intervals of 5/10/20/30/60 seconds.
Video Stamp
This setting will embed the Date/Time on the corner of your Video Footage. It is OFF
by default. You may toggle the following: Date/Time/Date & Time.
To Next Page
Loading...
