System Settings
Tv Mode
Select the output mode for your TV: NTSC/PAL
Light Frequency (Light Source)
Default setting is Auto. However, if you experience any light strobing in your footage
you may manually select 50/60hz
OSD – On Screen Display
Toggle whether in Video/Photo Capture Mode the user interface is displayed.
Auto Shutdown
This will power off the camera after a period of inactivity.
Intervals of 1/3/5 Minutes.
Screen Off
This setting lets you conserve power while shooting. It will switch off the LCD
screen after the set interval: 30seconds/1/3/5 minutes.
Status LED
Select the amount of Status LED lights the camera uses. Default is set to 4.
WiFi LED
Disable the WiFi LED while using WiFi.
TV Out
Enable or disable the TV output. Default is set to ON
Beep
Select whether the camera makes any sound when confirming/scrolling.
Microphone Volume
Set the microphone capture level. Default is 80%
Intervals of Off/ 50% / 60% / 70% / 80% / 90%/ 100%.
Sharpness
This setting controls how much detail and how sharp images appear. Intervals of
Strong/Normal/Soft.
To Next Page
Loading...
