Kaiweets KC601 - Page 19

personal injury.
Non-contact AC voltage detection (NCV)
/A\When using NCV function, remove the probe, otherwise the detection sensitivity will be affected.
button to turn on the power supply of the meter. After the self-test is completed, the
meter will display “Auto” and enter the smart measurement mode.
button, set the pointer to the "NCV/Live" position.
3. Then NCV probe gradually approaches the detected point.
4. When the weak electic field signal is induced, the "~L" symbol will be displayed, the beep will
emit a slow beep sound, and the green LED indicator will light up.
5. When the strong electric field signal is induced, the "H" symbol will be displayed, the beep wil
emit a fast beep sound, and the red LED indicator will light up.
Note: Before using the NCV function, remove the test leads. Otherwise, the detection accuracy will
be affected.
18