Kaiweets KM201 - Page 7

Measurement operation
Auto Mode
/i Don't use it to test voltage over 600V, the meter may be damaged. Always test known voltage with the meter before
using to confirm the instrument function is intact.
1) Long press the “(& " to power on, and the display shows “AUTO”, it defaults AUTO mode. Or Short press “(@A)”
to select AUTO mode.
2) Connect the test leads o the source or load to be measured.
3) The meter automatically recognizes voltage, resistance, and continuiy.
4) Read the measurement result from the display.
Note: If the resistance value of the measured resistor or circut is less than 5000, the buzzer will beep and the green
backlight will be lt.
NCV measurement,
1) Short press the (@) button to switch to NCV function.The meter will display “NCV”.
2) Then NCV probe gradually approaches the detected point.
3) When the meter senses weak AC signals, the green backlight lits and meter beeps slowly.The display shows
4) When the meter senses strong AC signals, the red backlight lits and meter beeps fast. The display shows “~