Kaiweets KM601s - Live Wire Detecting; Live Wire Detection Procedure

When the Meter detects a weak signal, the green indicator will light up, the buzzer will beep in a
slow tone, and ‘ —-L " will be displayed on the screen.
When the meter detects a strong signal, the red indicator will light up, the buzzer will beep in a fast
tone, and * ~-H " will be displayed on the screen
Live wire detecting
1. Press the “Ame’ button to ‘ tiee * setting, NGV’ signal will be displayed on the screen.
2. Press the ‘(%] button to display the ‘LIVE’ symbol. Insert the red probe into the ‘INPUT’ jack
and remove the black probe.
3. Touch the object under test with the red test lead point.
NOTE:
1. When the indicator light lights up that means the measured position for the fire line, please be
carefull
2. When the Meter detects a weak signal, the green indicator will light up, the buzzer will beep in
a slow tone, and *
L’ will be displayed on the screen. This means the test leads may not be fully
connected to the socket, please test again after full connection.
3. When the meter detects a strong signal, the red indicator will light up, the buzzer will beep in a
fast tone, and ‘ ==H * will be displayed on the screen.
17