Kaiweets KM602 - Page 14

Open circuit voltage: about 3V
Temperature measurement
(1) Long press " ()" button for about 2 seconds to power on, display Auta and enter the intelligent
measurement mode.
(2) Press "[w)" bution to select "¢ gear, "C" signal and "°F" signal will be displayed on the screen
(DefaultTs °F), indicating temperature testing.
(3) Insert the positive pole of the K-type thermocouple into the "INPUT" jack and the negative pole into
the "COM" jack.
(4) The thermocouple probe contacts the measured object.
(5) Read the results from the display.
Non-contact AC voltage detection
(1) Long press "())" button for about 2 seconds to power on, display Auta and enter the intelligent
measurement mode.
(2) Press "[]" button to select "NCV /Live" gear, "NCV" signal will be displayed on the screen,
indicating the NCV testing.
(3) Place the NCV sensor area closer to the point to be tested gradually.
(4) When the weak electric field signal is detected, it will display "-L"; the buzzer will sound slowly;
when the strong electric field signal is detected, it will display "~-H", the buzzer will sound quickly
13