Kaiweets KM602 - Page 2

Safety Specificatio
/A\Warning
To avoid possible electric shock or personal injury, please observe the following
specifications:
© Please read this manual carefully and pay special attention to safety waring information before
using the meter.
® Operate the meter according to the manual, otherwise the protection function provided by the
instrument may be damaged or weakened.
® Take special care when measuring values that above 60V dc, 30V ac RMS, 42V peak. This kind of
voltage has the danger of electric shock.
® Do not measure voltage higher than the rated value between terminals or between terminals and
ground.
® Measure the known voltage to check whether the meter works normally. If it is not normal or
damaged, please do not use it again.
© Before using the meter, please check whether there are cracks or damaged plastic parts in the
instrument shell. If so, please do not use it again.
© Before using the meter, please check whether the probe is cracked or damaged. If so, please
replace the probe with the same model and electrical specification.
® Please use the meter according to the measurement category, voltage or current rating specified in
the meter or manual
@ Please observe local and national safety regulations. Wear personal protective equipment (such as
EN
1