Kaiweets ST600X - Battery Installation

Install Batteries
+ T3 signa will be displayed on the screen when the battery is low.
1) Remove test leads from the Meter before opening the case or battery door.
2) Remove the screw and remove the battery door.
3) Install 4 x 1.5V AAA batteries. *Please pay attention to the battery polarity.
4) Then inserted into the battery door. Install and tighten the battery door screw.
Warning
® To avoid electric shock or personal injury caused by wrong reading, please replace the
battery immediately when the battery is low.
® Do not discharge the battery by shorting it or reversing its polarity.
® To operate and maintain the Meter safely, please take out the battery when it is not used
for a long time to prevent the battery leakage from damaging the product.
22