Kaiweets ST600X - Fuse Replacement

Replace Fuses
* £+ " signal will be displayed on the screen when the fuses are blown, current testing function is not
working, please change the fuses.
1) Tum off the Meter power and remove the probes.
2) Remove the screw fixing the back cover and remove the back cover.
3) Remove the bumt-out fuse, replace it with a new one of the specification(F10A/250V fuse), and
ensure that the fuse is installed in the safety clip and clamped tightly.
4) Install the back cover and fix it with screws
Warning
® Use ONLY a fuse with the amperage, interrupt voltage, and speed ratings specified.
® Do not use the Meter if the back cover is opened.
23