3.1 Electrical power requirement
Before connecting the machine to the power,
check that :
- The tension of the machine corresponds
with the tension of your electrical network.
- The electrical connection requires a plug
compatible with CEI 60309-1.
- The electrical connection should comply with
installation norm NFC 15 100.
3.2 Installation
- Install the laminator on a flat and stable floor,
next to an easily accessible plug.
- Do not touch the socket with damp hands.
- To unplug the machine, disconnect the plug
without pulling on the supply lead.
- To prevent electric shocks, do not use this
laminating machine close to water.
- Leave a large enough working area in front
and behind the machine.
- Do not spill water on the machine, the supply
lead or the electric socket.
- Do not use the machine if the supply lead is
damaged.
- Do not leave the electric lead in contact with a
warm surface.
- The machine should be installed in a well-
ventilated place.
3.3 Safety information :
User’s risks indication
According to the actual regulations listed in (#1),
user’s risks are located and noticed on the
laminator in the following manner :
Electrical shocks hazards :
This sign indicates that there
are electrical components
inside the machine. Opening
this area should be done by
aqualified technician when the
machine is off tension and not
linked to the power.
Crushing risk
This sign on the feeding tray
alerts about risks for fingers,
hands, clothes, hairs… to be
crushed into the rollers either
spinning or being set into
pressure.
To Next Page
Loading...
Need help?
General
