DCW BedienA Pedelec_RZ5.qxd
Error Remark Blinking LEDs Blinking interval - a field corresponds to 0.5 sec
Directly after
switching on
Upper power diode
Middle power diode
Following this 1 to 3 diodes light up depending on the residual capacity
Self configuration
Lower power diode
“High” mode
“Medium” mode
and further start support mode
“Low” mode
Battery dead Lower power diode
and further no electric support
Position error of
the torque pickup
Two power diodes
All three mode diodes
and further no electric support. Reset
necessary
Motor unit
defective
Two power diodes
All three mode diodes
no electric support. Motor
unit defective
Overload One mode diode
no blinking when
cooled
Reduce support degree by
two steps
Strong overload One mode diode
no blinking when
cooled
Reduce support degree by
1 step
Transmission error Last power diode
and further Reduce support degree by
2 steps
Reset Press “Off” and “On” twice to reset.
Position error of the torque sensor To avoid this error do not use the pedals for the first two seconds after switching on
Error search
Have the electric drive checked regularly by your dealer. Do not perform any repair operations on the electric drive system or battery.
lack of specialist knowledge may lead to serious accidents.
The following tips are only to be considered as guidelines. You should not hesitate to contact your dealer if you have a problem with
the electric drive or with the battery.
To Next Page
Loading...
