KanexPro WP-IPKEYPAD8 - 6.3 Telnet Commands

WP-IPKEYPAD8D
6 | P a g e
6.3 Telnet Commands
COMMAND
DESCRIPTION
IPCONFIG
Display the current IP
configuration.
SETIP N, N1, N2
Set static Ethernet IP, netmask,
and gateway addresses
simultaneously.
N=X.X.X.X (IP Address)
N1=X.X.X.X (Netmask)
N2=X.X.X.X (Gateway)
X=0~255
SIPADDR X.X.X.X
Set Ethernet IP address.
X=0~255
SNETMASK X.X.X.X
Set Ethernet netmask.
X=0~255
SGATEWAY X.X.X.X
Set Ethernet gateway.
X=0~255
SIPMODE N
Set Ethernet IP mode.
N=STATIC, DHCP
VER
Show unit's firmware version.
FADEFAULT
Set all configurations to factory
defaults.
ETH_FADEFAULT
Reset all Ethernet settings to the
factory defaults.
REBOOT
System reboot.
HELP (?)
Show command list.
HELP N
Show description of command.
N={Command Name}