KanexPro WP-IPKEYPAD8 - Page 12

WP-IPKEYPAD8D
7 | P a g e
COMMAND
DESCRIPTION
KEY_PRESS N HOLD
Set key press macro activation
method to "Hold". (Macro
activates when key is pressed.
Macro will repeat if the key is
held down.)
N=1~16 (Key Number)
MACRO RUN N
Run the specified macro.
N=1~32 (Macro ID)
MACRO STOP
Stop all currently running macros.
MACRO STOP N
Stop the specified macro.
N=1~32 (Macro ID)
DEVICE ADD N N1 N2 N3
Add Telnet device definition to
slot N.
N=1~16 (Device Slot Number)
N1=X.X.X.X (IP Address, X=0~255)
N2=0~65535 (Port)
N3={Name} (Up to 24 characters,
no spaces)
DEVICE DELETE N
Delete Telnet device definition in
slot N.
N=1~16 (Device Slot Number)
DEVICE N N1
Enable/Disable defined Telnet
device.
N=ENABLE, DISABLE
N1=1~16 (Device Slot Number)
Note: Commands will not be executed unless followed by a carriage
return. Commands are not case-sensitive.