- Data Brochure
Mixing Control 360e
D 360e
06/03
1 of 20 © 2003 D 360e - 06/03
The Mixing Control 360e is designed to control the supply water temperature to a hydronic system in order to provide outdoor
reset or setpoint operation. The control uses a floating action mixing valve to regulate the supply water temperature, while
protecting the boiler against flue gas condensation. The control has a Liquid Crystal Display (LCD) to view system status and
operating information.
Additional Functions Include:
• Quick Setup for easy installation and programming of
control
• User comfort adjustment to increase or decrease build-
ing space temperature
• Advanced settings to fine-tune building requirements
• Boiler Control for improved energy savings
• Powered mixing system pump output
• Optional indoor sensor for room air temperature control
• Test sequence to ensure proper component operation
• Setback input for energy savings
• 230 V (ac) power supply
• CE Approved
Input
Mixing
Demand
Signal
Output
Mixing System
Pump
Input
Indoor
Sensor
Optional
Input
Universal Sensor
Included
Input
Universal Sensor
Included
Input
Outdoor
Sensor
Include
Output
Boiler
Input
230 V (ac)
Power
Supply
Input
kanmor Timer
Optional
Output
Mixing Valve &
Actuating Motor
Do not apply power
Signal wiring must be
rated at least 300 V.
LNPmpN Sw
Sys
UnO Com Boil
Mix
Pwr Opn Cls Mix Com Out Indr
1 3 52
4
6
91078 11 12
13 14
15
16 17
18
Mix
Power
Boiler
Demand
Advanced
Installer
Boiler Sensor
Supply
30% Enable
10% Enable
Return
Item
Test
Terminal
Unit
Mixing
Demand
INSTALLATION CATEGORY II
Made in Canada
Power: 230 V ±10% 50 Hz 2300 VA
Relays: 230 V (ac) 10 A 1/3 hp, pilot duty 240 VA
Demand: 20 to 260 V (ac) 2 VA
H1211B
To increase or decrease the
building temperature:
• Press the Item,▲,▼ buttons
simultaneously for 1 sec. to
enter the ADJUST menu
• Use the ▲,▼ buttons to adjust
the ROOM setting
Display defaults back to VIEW
menu after 20 seconds.
ROOM
-
Set to desired room temperature.
OUTDR DSGN
-
Set to coldest (design)
outdoor temperature.
Terminal Unit Set to
High Mass Radiant 1
Low Mass Radiant 2
Fan Coil 3
Convector 4
Radiator 5
Baseboard 6
Refer to brochure for more information.
Installer Instructions
Mixing Control 360e
Floating Action
Open
Motor
Speed
Close
M